How To Tie In A Peep Sight

How to Properly Tie in a Peep Sight

How to tie in a peep sight properly is one of the fundamental skills any bow mechanic should primary. It's an overlooked attribute of equipment setup that not simply ensures the peep doesn't move as you shoot, but information technology can as well forestall serious middle injury in the event of a dry-fire or string failure. Follow these steps to learn how to necktie in a peep sight the correct fashion.

I've seen a number of peep sights get flying, ricocheting off the riser and nearby people after a bow was dry-fired. One example drew claret on the cheek of an innocent bystander. Another nearly ended a tournament archer's day until the search party got lucky and plant the peep.

One time my peep height is adamant, serving it is always the next step to ensure consistency in my sight settings and forbid loss.

Outset past cut a 2-foot length of small-diameter serving thread. And then, wedge one end in the bottom "Y" split created by the peep to agree it in identify.
Concord the long stop against the cord above the peep and begin wrapping over the short tail held against the string.
Every bit y'all apply more than wraps, increment tension, and move the parcel downwards toward the peep until the wraps are pulled together.
After about 9 wraps, pull the brusk tail from between the strands and do 2 more wraps, standing in the same management, downwards one side of the "Y" dissever, toward the peep.
Next, wrap the serving all the way around the peep's string groove in the aforementioned direction.
Now loop the long stop through the string below the peep on the same side and pull tight.
As you sure-fire tight, the serving should slip betwixt the string and peep, locking the peep to the cord.
Side by side, make another half wrap over the peep groove and loop the serving through the string and effectually the opposite side of the cord packet above the peep.
Again, cinch the long cease tight to lock the other side in. Steps 6–nine are disquisitional for safety and are certain to keep the peep from moving during a hunt.
Now, go on wrapping up the other side of the string for two wraps toward the "Y" where the string comes back together.
At this point, pull about a 4" loop out and have the loose end of serving over the cord in the same management and through the loop.
Holding the loop tight, wrap ix times back toward the peep inside of the loop with the loose end. The loose end is between my finger & thumb in the photo.
Side by side, motility the loose cease upwards toward the peep and pinch information technology against the string.
Now, employ the loop to wrap over the loose end starting at the "Y" and moving abroad from the peep. As you wrap over the loose end, the other end will unwrap.
When y'all finish the back wrap, at that place will exist a loop left over.
Pull the loose end by hand and the loop will pull under the wraps of the serving.
Next, apply a plier to pull each of the loose ends tight. This will cinch the wraps downwards above and below the peep.
Use a abrupt knife or razor to cut each finish and fuzz the stop with your fingertip.
Carefully burn down each stop, always keeping the flame above the bowstring.
The finished peep should look like this!